Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual23 · BR brake system
23 · Brakes

CYLINDER BODY - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER BODY - Nissan 180SX S13 Workshop Manual
BR brake systemCYLINDER BODY - Nissan 180SX S13 Workshop Manual

CYLINDER BODY

FRONT DISC BRAKE (CL18VB, CL25VA) — Caliper

Inspection

CYLINDER BODY

@ Check inside surface of cylinder for scoring, rust, wear, damage or foreign materials. Replace if any such condition exists. @ Eliminate minor damage from rust or foreign materials by polishing surface with fine emery paper.

CAUTION: Use brake fluid to clean. PISTON Check piston for scoring, rust, wear, damage or foreign mate- rials. Replace if any condition exists.

CAUTION: Piston sliding surface is plated. Do not polish with emery paper even if rust or foreign materials are stuck to sliding surface.

PIN, PIN BOLT AND PIN BOOT

Check for wear, cracks or other damage. Replace if any condition exists.

Assembly @ Place piston boot over rear of piston. Fit piston boot’s lip properly in corresponding groove on cylinder body. @ Insert piston into cylinder body and fit boot’s lip properly in corresponding groove on piston.

SBR480A

Inspection (On-vehicle)

INSPECTION OF BRAKE DRAG FORCE

1. Swing cylinder body upward.

2. Make sure that wheel bearing is adjusted properly. Refer to section FA.

3. Measure rotating force (F,).

SBR4564 install caliper with pads to original position.

Depress brake pedal for 5 seconds. Release brake pedal and rotate disc rotor 10 revolutions. Measure rotating force (F.). Calculate brake drag force by subtracting F; from Fo. ON Maximum brake drag force (F: - F,):

Op OG

59.8 N (6.1 kg, 13.5 Ib) If it is not within specification, check main pins and retainer boots in caliper.

SBR457A BR-15

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.