Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual27 · EL electrical system
27 · Electrical

Aiming Adjustment - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › Aiming Adjustment - Nissan 180SX S13 Workshop Manual
EL electrical systemAiming Adjustment - Nissan 180SX S13 Workshop Manual

Aiming Adjustment

HEADLAMP

Aiming Adjustment

When performing headlamp aiming adjustment, use an aiming machine, aiming wall screen or headlamp tester. For operating instructions of any aimer, it should be in good repair, calibrated and used according to respective operation manuals supplied with the unit. if any aimer is not available, aiming adjustment can be done as follows: For details, refer to the regulations in your own country.

CAUTION:

a. Keep all tires inflated to correct pressures.

b. Place vehicle and tester on one and same flat surface.

c. See that there is no-load in vehicle (coolant, engine oil filled up to correct level and full fuel tank) other than the driver (or equivalent weight placed in driver’s position).

LOW BEAM

1. Turn headlamp iow beam on.

2. Use adjusting screws to perform aiming adjustment. commie @ First tighten the adjusting screw all the way and then make adjustment by loosening the screw. —_— ATUL

SEL400L

a. Adjust headlamps so that main axis of light is parallel to Horizontal “H"': center line of body and is aligned with point P shown in center lina illustration. of headlamps

b. Figure to the left shows headlamp aiming pattern for driving on right side of road; for driving on left side of road, aiming pattern is reversed.

c. Dotted lines in illustration show center of headlamp. “H”: Horizontal center line of headlamps “WL”: Distance between each headlamp center “LL”: 5,000 mm (196.85 in) “G": 50 mm (1.97 in) Height of Vertical centertine ahead of headlamps lamp centers P ty |

wW = ACCEPTABLE RANGE

SEL2641

EL-46

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.