Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual27 · EL electrical system
27 · Electrical

REAR WINDOW DEFOGGER - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › REAR WINDOW DEFOGGER - Nissan 180SX S13 Workshop Manual
EL electrical systemREAR WINDOW DEFOGGER - Nissan 180SX S13 Workshop Manual

REAR WINDOW DEFOGGER

REAR WINDOW DEFOGGER

Filament Repair

REPAIR EQUIPMENT

4. Conductive silver composition (Dupont No. 4817 or equiva-

jent) Ruler 30 cm (11.8 in) long Drawing pen Heat gun Alcohol ANON Cloth

REPAIRING PROCEDURE

1, Wiper broken heat wire and its surrounding area clean with

a cloth dampened in alcohol. (0.20) 5 (0.20) 5 r oe

2. Apply a small amount of conductive silver composition to tip

{ Heat wire wa of drawing pen. rad

Shake silver composition container before use.

s j ~d

3. Place ruler on glass along broken line. Deposit conductive

T ry ¥ ee a

silver composition on break with drawing pen. Slightly

overlap existing heat wire on both sides [preferably 5 mm

Ruler (0.20 in)] of the break. Unit: mm lin} Drawing pen BE540

4. After repair has been completed, check repaired wire for

continuity. This check should be conducted 10 minutes after

r Repaired point silver composition is deposited.

Do not touch repaired area while test is being conducted.

af fe = seL012D wH—/

5. Apply a constant stream of hot air directly to the repaired

area for approximately 20 minutes with a heat gun. A

‘7 Repaired point

minimum distance of 3 cm (1.2 in) should be kept between

repaired area and hot air outlet. If a heat gun is not available,

4 let the repaired area dry for 24 hours.

Heat gun SELO130

EL-76

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.