Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual27 · EL electrical system
27 · Electrical

WIPER AND WASHER - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › WIPER AND WASHER - Nissan 180SX S13 Workshop Manual
EL electrical systemWIPER AND WASHER - Nissan 180SX S13 Workshop Manual

WIPER AND WASHER

———a =

WIPER AND WASHER

itt 5

Wiper Arm (For Europe L.H.D. model)

The wiper arm pressure is controlled by the vehicle speed when

the wiper switch is in the “ON” position.

Vehicle speedkm/h (MPH)Wiper arm pressure
More than130 (81)Low > High
Less than120 (75)High > Low

SEL704L

Wiper and Washer Adjustment

INSTALLATION

1. Prior to wiper arm installation, turn on wiper switch to operate wiper motor and then turn it “OFF” (Auto Stop).

2. Lift the blade up and then set it down onto glass surface to set the blade center to clearance “‘L:” & “L2” immediately before tightening nut.

3. Eject washer fluid. Turn on wiper switch to operate wiper motor and then turn itt “OFF”.

4. Ensure that wiper blades stop within clearance “L.” & “Le”. Clearance “Li”: 17.5 - 32.5 mm (0.689 - 1.280 in)

Clearance “L.”: 25 - 35 mm (0.98 - 1.38 in)

@ Tighten wiper arm nuts to specified torque.

Front wiper: 17 - 23 N-m (1.7 - 2.3 kg-m, 12 - 17 ft-Ib)

Rear wiper: 13 - 18 Nem (1.3 - 1.8 kg-m, 9 - 13 ft-lb)

L.H.D.

| H All the diameters of these circles are less *5 *6 than 80 (3.75). + *7 *8

503 (19.80) *2: 275 (10.83) *3: 425 (16.73) ¥a: 213 (8.39) 5: 144 (5.67) 155 (6.10) *7: 273 (10.75) *g: 385 (15.16)

Unit: mm (in) Lower windshield molding SEL449i

EL-70 oe)

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.