Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual27 · EL electrical system
27 · Electrical

WIPER AND WASHER - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › WIPER AND WASHER - Nissan 180SX S13 Workshop Manual
EL electrical systemWIPER AND WASHER - Nissan 180SX S13 Workshop Manual

WIPER AND WASHER

WIPER AND WASHER

Wiper Removal and Installation

3.8-5.1 \ ee ee

0.39 - 0.52, 2.8 - 3.8} “© 38-51 Ns \ . Sr - 0.52, 2.8 - 3.8) == Vn? He 5) ar eel POTS ~ »te > re

, (} : N-m (kg-m, ft-lb)

SEL410L

FRONT WIPER REMOVAL

Cowl top

Before removing front wiper motor link, turn wiper switch OFF

ae front panel Pull and disconnect motor leads at connectors. = straight Remove wiper arm. ahead. Remove cowl cover. Remove bolts which secure wiper motor. BON Extract wiper motor so that wiper motor link comes out of hole in front cow! top panel. Then, pull motor straight out to disconnect ball joint which connects motor link and wiper link. Wiper motor can then be removed.

5. Remove wiper link pivot blocks on driver and passenger SEL474L sides.

6. Extract wiper link and pivot blocks (as one unit) from oblong hole on left side (L.H.D.) or right side (R.H.D.) of cowl top.

FRONT WIPER INSTALLATION

1. Position wiper link and pivot blocks (as one unit) in cowl top through oblong hole. — Cow! top | front panel

2. Before installing pivot blocks on cowl top, hold end (motor link side) of wiper link at hole in front cowl top panel and insert motor link’s ball pin into hole in wiper link.

3. Install front wiper in reverse order of above removal proce- dures. @ Apply a small amount of grease to ball joints before installation. SELAT2L

EL-68

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.