METER AND GAUGES - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › METER AND GAUGES - Nissan 180SX S13 Workshop Manual
METER AND GAUGES
METER AND GAUGES
Inspection/Fuel Gauge and Water Temperature
Gauge
C INSPECTION START )
r
CHECK POWER SOURCE.
Check the following items. 1) Turn ignition switch “ON”. N.G.) 1) Harness continuity between 2) Check voltage between > SEL76IL battery terminal and terminal @ and ground. cambination meter BI > Battery voltage should exist. 2) ignition relay 3) Fusible link and fuse (Temp.} ® O.K. 4) Ignition switch {Fuel} BI 7 N.G.
CHECK GAUGE OPERATION.
> Repair or replace gauge. 1) Turn ignition switch “ON”. 2) Connect terminals () (Fuel),
® (Temp.) and ground with
Fuel gauge wire for lass than 10 seconds, (®: Water temperature gauge 3) Check operation of gauge. SEL762L Gauge should move smoothly to full scale. O.K. ¥. N.G. Repair or replace. Check harness continuity + between component and (Fuel) combination meters ©) (Fuel),
© (Termp.).
Fuel gauge ©): O.K, Water temperature gauge SEL763L q
CHECK COMPONENT.
Repair or replace. Check gauge units and harness. Refer to FE section. (Fuel gauge) Refer to “Fuel Tank Gauge Unit Check” or “Thermal Transmitter Check”. O.K. . y Reinstall any part removed.
r (
INSPECTION END
)
EL-59
Parts & tools for this job For Nissan 180SX
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
As an Amazon Associate we earn from qualifying purchases.