Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual16 · Top Cover Assembly
16 · General

Top Cover Assembly - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Top Cover Assembly - Nissan 240SX 1991-1992 Workshop Manual
Top Cover AssemblyTop Cover Assembly - Nissan 240SX 1991-1992 Workshop Manual

Top Cover Assembly

TOP COVER ASSEMBLY

11-8 TOP COVER ASSEMBLY (cont'd)

INSTALL TOP COVER TO TACK STRIP.

4. Starting at rear window opening, use .31 x .31 monel staples on single layers and .50 x 31 stainless steel divergent staples on multiple layers.

NOTE: Keep material taut while maintaining top cover alignment to tack strip upper edge.

INSTALL RIGHT AND LEFT SIDE RETENTION CABLES TO

TOP COVER.

NOTE: Use of a stiff wire attached to cable end will aid installation of retention cables.

INSTALL TOP COVER AND TACK STRIP TO REAR DRAIN

TROUGH ASSEMBLY.

Gently pull inward on tack strip ends while positioning tack

(a) strip to mounting studs. Install seventeen (17) nuts to tack strip studs. (b)

Tighten nuts starting from the center, than working out. Do

(c) not torque nuts at this time.

INSTALL TOP COVER TO NO. 3 AND NO. 2 BOWS.

Install No. 3 bow top cover retainer to top cover. (a) Install three (3) screws to No. 3 bow and top cover retaine! (b) Repeat (a) and (b) for No. 2 bow. (c)

INSTALL TOP COVER TO SEAL CARRIERS.

Apply adhesive (3M P/N 0511 35-08031o0r equivalent) to (a) seal carrier top cover area and top cover glue flap.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.