Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual16 · Top Cover Assembly
16 · General

Top Cover Assembly - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Top Cover Assembly - Nissan 240SX 1991-1992 Workshop Manual
Top Cover AssemblyTop Cover Assembly - Nissan 240SX 1991-1992 Workshop Manual

Top Cover Assembly

TOP COVER ASSEMBLY

11-9

TOP COVER ASSEMBLY (cont'd)

(b) Position top cover wear flap on outside of seal carrier and fold glue flap material into seal carrier.

NOTE: Top cover binding should be straight and turned slightly inward.

9.

INSTALL TOP COVER ASSEMBLY TO NO. 1 BOW.

(a) Secure right and left retention cables to No. 1 bow using two (2) screws.

(b) Apply adhesive (3M P/N 051135-08031 or equivalent) to top cover area of No. 1 bow and top cover material.

(c) Fold side flap material under bow aligning front edge of flap with edge of bow. (d) Fold top cover material over No. 1 bow aligning reference line to No. 1 bow front edge.

10.

CHECK TOP COVER ASSEMBLY FIT.

(a) Raise and latch convertible top to header. (b) Check top cover fit at No. 1 bow, tack strip and seal carriers. Make adjustments as required. (c) Release convertible top from header.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.