Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K806 Engine - K1607 Engine - K16 with VVC08 Engine - L Series09 Emission control10 Engine management system - MEMS11 Engine management system - EDC12 Fuel delivery system13 Cooling system - K Series14 Cooling system - L Series15 Manifold & exhaust systems16 Clutch17 Manual gearbox - R6518 Manual gearbox - PG119 Automatic gearbox - CVT20 Automatic gearbox21 Drive shafts22 Steering23 Front suspension24 Rear suspension25 Brakes26 Restraint systems27 Body28 Heating & ventilation29 Air conditioning30 Wipers & washers31 Electrical32 Instruments
Rover 200 Workshop Manual (1995-1999)27 · Body
27 · Body & interior

Rear screen

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Screens › Rear screen
BodyRear screen · page 1 of 3

REAR SCREEN

Service repair no - 76.81.10

NOTE: The following equipment is required:

Cutting wire and handles. Windscreen repair kit. Sealer applicator gun. Suction cups.

WARNING: Wear protective gloves when handling glass, solvents, and primers.

WARNING: Wear suitable eye protection when removing and refitting glass.

Remove

  1. Remove rear screen wiper motor. See WIPERS & WASHERS, Repairs.
  2. Remove tailgate spoiler. See Exterior fittings.
Rear screen – Remove tailgate spoiler. See Exterior fittings.
  1. Disconnect 2 leads from rear screen demister.
  2. Fit protection to rear of vehicle.
  3. Fit protective cover to interior of vehicle.
Rear screen – Fit protective cover to interior of vehicle.
  1. Carefully run a sharp blade around rear screen and remove outer lip of screen finisher.
  2. Insert cutting wire through sealant at bottom corner of screen.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.