Fault finding
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Information › Fault finding
Heating and ventilationFault finding
Turn the ignition switch off.
Remove the heater control panel.
Disconnect the 8P connector from the heater fan switch.
Disconnect the 5P connector from the blower resistor.
Check each wire for continuity between the heater fan switch and earth.
* BLU wire
* BLU/WHT wire
* BLU/YEL wire
* BLU/BLK wire
* BLU/RED wire
Is there continuity?
NO — Replace the heater fan switch.
YES — Repair short in wire(s) between the heater fan switch and the blower resistor.
FAULT FINDING
Parts & tools for this job For Rover 600
- TOOLA/C manifold gauge setSearch: AC manifold gauge set
- TOOLUV leak detection kitSearch: AC UV leak detection kit
- PARTCabin filterSearch: Rover 600 cabin filter
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.