Power transmissionGear drive mechanism: repairing
| Gearbox action: adjustment |
| Special tools and workshop equipment required |
|
|
|
| t
| Gear stick adjustment tool -U-40026- |

Note! | t
| In order to adjust the gearbox driver correctly, it is necessary to take the following points into account: |
| t
| The vehicle must have its four wheels securely on the ground or on an paralell elevator |
| t
| All gearbox actioning elements must be in perfect working order |
| t
| The gearbox action must be smooth, with no harshness |
| t
| The gearbox, the clutch driver and the clutch, must be in perfect condition |
|
|
|
| –
| Loosen the control rod clamp -arrow 1-. The control rod/selector lever joint must move freely. |
| –
| Remove the frame cover and turn over. |
|
|
|
| –
| The gear stick eccentric adjuster -A- should be facing the reverse hook -arrow-. |
|
|
|
| –
| Fit tool -U-40026- without using force, so that the guide tab -arrow 1- fits into the groove in the tool and the gear stick hook fits into the tool orifice -arrow 2-. |
| –
| The tool must not get jammed. |
| –
| Align the control rod and the angled finger without using force. |

Note! | Check that the geabox has no gear selected (neutral position) |
|
|
|
| –
| Tighten the securing nut of the clamp -arrow 1-. |
| l
| The gear lever must be in neutral, in the 3rd and 4th gear trail |
| –
| Select all the gears several times. Check especially the reverse gear selection. |
| If on selecting a gear several times there is still stiffness, do the following: |
| –
| Eliminate gear action play, pressing the gear stick carefully left. |
|
|
|
| l
| Distance betweent the protection box and the reverse gear hook = 1 … 1.5 mm (dimension -a-) |
| –
| If this were not the case, effect a fine adjustment → |
|
|
|
| –
| Loosen securing bolt -B-. |
| –
| Eliminate gear action play, pressing the gear stick carefully left. |
| l
| Distance between the protection box limit and the reverse gear hook = 1 … 1.5 mm (dimension -a-) |
| –
| Obtain the correct dimension -a- by turning (left or right) the excentric adjuster -A-. |
| –
| Loosen securing bolt -B-. |
| –
| Fit the gear stick cover to the frame. |
| Eccentric securing bolt: 2 Nm |
|
|
|
01 Transmission
The same page in:
Leon Mk2.