Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk101 · Power transmission
01 · Transmission

Gearbox housing cover

Make
SEAT
Model
Leon Mk1
Section
0AJ 6-speed manual gearbox › Gearbox mechanics,operation, construction,diff. › Gearbox housing cover
Power transmissionGearbox housing cover
Repairing gearbox housing cover
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
   
Gearbox housing cover – SEAT Leon Mk1
Special tools and workshop equipment required
t  Terminal crimper -VW 412-, see equivalent → Anchor
t  Inlay socket -40-21-, see equivalent → Anchor.
t  Support bridge -2011-
t  -1-Interior extractor -Kukko 21/5-
t  -4-Support bracket -Kukko 22/2-
t  Hot air blower -V.A.G 1416-, see equivalent → Anchor

   
Release the roller bearing socket from the gearbox casing cover
A  - Internal remover 28... 37 mm, e.g. -Kukko 21/5-
B  - Counter-support, e.g. -Kukko 22/1-
  N34-1560
Insert the roller bearing socket on the gearbox casing cover
–  Use the hot air blower -V.A.G 1416- and heat the gearbox casing cover in the region where the bearings are seated to a temperature of approx. 100 °C.
–  Place the roller bearings in the previously heated casing and press with the workshop press until the heat is transferred.
Gearbox housing cover – SEAT Leon Mk1  Note
The roller bearings must be fitted in the cover as far as possible. Do not tighten with the countersunk bolts through the support plate.
  N34-1561

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.