Vehicle electricsStarter motor: removing and fitting
| Vehicles with 1.6 and 1.8 litre turbo engine |
| –
| With the ignition switched off, disconnect battery earth cable → Chapter. |
|
|
|
| –
| Loosen the screws or quick-type locks -1 - and - 2- and remove front noise insulation. |
|
|
|
| –
| Unscrew the cable of terminal B+ -item 2-. |
| –
| Separate the plug connection for terminal 50 -item 1-. |
| –
| If fitted, detach insulator at positive connection of starter. |
| –
| Unscrew the wire clip -4- |
| –
| Unscrew bracket for starter at cylinder block -3- and starter. |
|
|
|
| –
| Unscrew bolts -1- and -2-. |
| –
| Take out starter motor downwards. |
| Installation is carried out in reverse order, noting the following: |
| –
| Connect battery. Steps required → Anchor. |
|
|
|
| Components: | Nm |
| Starter motor: | M10: | 45 |
| to gearbox | M12 | 65 |
| Terminal B+ to starter | 16 |
06 General
The same page in:
Leon Mk2.
