7.INSTALL CRANKSHAFT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REASSEMBLY › 7.INSTALL CRANKSHAFT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
7.INSTALL CRANKSHAFT

c. Using a vernier caliper, measure the distance between the crankshaft bearing cap edge and crankshaft bearing edge. Dimension A - B or B - A: 0 to 0.7 mm (0 to 0.0276 in.)
13411
7.INSTALL CRANKSHAFT
a. Apply engine oil to the crankshaft bearing, and then install the crankshaft to the cylinder block sub- assembly.
b.

*1 Lower Crankshaft Thrust Washer *2 Upper Crankshaft Thrust Washer
Apply engine oil to the 2 upper crankshaft thrust washers and 2 lower crankshaft thrust washers.
HINT: Check the crankshaft thrust washers, as there are different types as shown in the illustration.
c.

*a Groove
Push the crankshaft in one direction and install one upper crankshaft thrust washer to the No. 5 cylinder block sub-assembly journal position with the oil groove facing outward.
d. Push the crankshaft in the opposite direction and install the other upper crankshaft thrust washer to the No. 5 cylinder block sub-assembly journal position with the oil groove facing outward.
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.