8.INSPECT CRANKSHAFT THRUST CLEARANCE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REASSEMBLY › 8.INSPECT CRANKSHAFT THRUST CLEARANCE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
8.INSPECT CRANKSHAFT THRUST CLEARANCE

i.

Step 1: Using several steps, install and uniformly tighten the 10 crankshaft bearing cap set bolts in the sequence shown in the illustration. Torque: 95 N*m (969 kgf*cm, 70 ft.*lbf)
HINT: If any of the crankshaft bearing cap set bolts does not meet the torque specification, replace the crankshaft bearing cap set bolt.
j. Step 2:
i. Mark the front of the crankshaft bearing cap set bolts with paint. ii. Tighten the crankshaft bearing cap set bolts by 90°. iii. Check that the painted marks are now at a 90° angle to the front.
k. Check that the crankshaft turns smoothly.
8.INSPECT CRANKSHAFT THRUST CLEARANCE
13041
9.INSTALL CONNECTING ROD BEARING
HINT: Check that the No. 1 and No. 2 connecting rod bearing colors are correct, as the colors differ. Bearing Color:
| Item | Connecting Rod Bearing Color |
|---|---|
| No. 1 Connecting Rod Bearing | Brown |
| No. 2 Connecting Rod Bearing | Silver |
a. Clean the backside of the connecting rod bearing and the connecting rod bearing surface of the connecting rod sub-assembly and connecting rod cap.
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.