3.INSPECT INTAKE VALVE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- INSPECTION › 3.INSPECT INTAKE VALVE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
3.INSPECT INTAKE VALVE

a.

Using a vernier caliper, measure the free length of the valve compression spring. Standard free length:
52.4 mm (2.06 in.) If the free length is not as specified, replace the valve compression spring.
b.

*a Deviation
Using a steel square, measure the deviation of the valve compression spring. Maximum deviation:
1.8 mm (0.0709 in.) Maximum angle (reference): 2° If the deviation is more than the maximum, replace the valve compression spring.
13711
3.INSPECT INTAKE VALVE
a. Using a gasket scraper, chip off any carbon from the intake valve head.
NOTICE: Be careful not to damage the intake valve face.
b. Using a wire brush, thoroughly clean the intake valve.
c. Using a vernier caliper, measure the overall length of the intake valve. Standard overall length:
99.98 mm (3.94 in.) Minimum overall length:
99.48 mm (3.92 in.) If the length is less than the minimum, replace the intake valve.
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.