Chain Wire - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Winch › Chain Wire - Toyota Land Cruiser J70 Workshop Manual
Chain Wire

WI-40 WINCH — Electric Winch
Chain Wire

REMOVAL OF CHAIN WIRE
REMOVE CHAIN WIRE
1,
(a) Shift the hub shift lever to the free position.
pare2 (b) Loosen the wing nut and turn the No. 1 support bracket 90°. (c) Pull out the No. 1 bracket support together with the chain wire from the drum.

REMOVE HOOK HOLDER FROM CHAIN WIRE
wio16
REMOVE WIRE LOCK

(a) Remove the drum housing cover and then pull out the lock plate from the drum. (b) Remove the wire lock and lock plate from the chain wire,
wi0093,
INSPECTION OF CHAIN WIRE

(See page WI-2)
INSTALLATION OF CHAIN WIRE
INSTALL WIRE LOCK
1.
(a) Insert the chain wire into the wire installation hole of the drum and drum housing cover hole. (b) Install the wire lock and lock plate to the end of chain wire with the two bolts. Torque the bolts. wig093, Torque: 195 kg-cm (14 ft-lb, 19 N-m) (c) Install the drum housing cover.
WINDING CHAIN WIRE
(a) Shift the hub shift lever in the locked position, and insert the lever lock pin into the hole of the hub shift shaft.

NOTE: If reaching the lever is difficult, move the drum by hand. 04183
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Land Cruiser
As an Amazon Associate we earn from qualifying purchases.