Workshop Manuals Factory service & repair Toyota
01 Toyota Land Cruiser J7002 Toyota Land Cruiser J70 - General
Toyota Toyota Land Cruiser J70 Workshop Manual01 · Toyota Land Cruiser J70
01 · Electrical

INSTALL HOOK HOLDER - Toyota Land Cruiser J70 Workshop Manual

Make
Toyota
Model
Land Cruiser Toyota Land Cruiser J70 Workshop Manual
Section
Winch › INSTALL HOOK HOLDER - Toyota Land Cruiser J70 Workshop Manual
Toyota Land Cruiser J70INSTALL HOOK HOLDER - Toyota Land Cruiser J70 Workshop Manual

INSTALL HOOK HOLDER

1984 LJ70 RJ70 Repair Manual 38261E: diagram

WINCH — Electric Winch wi-41

(b) Connect the remote control switch and start the engine. (c) Confirm that the “power” lamp goes out and place the switch on “IN.”” (d) Pull the chain wire tense and feed it to the winch as it winds.

1984 LJ70 RJ70 Repair Manual 38261E: diagram

CAUTION: The speed of the winch increases as the end of the cable nears. (e) Stop winding with about one meter (40 in.) of the wio103, chain wire remaining out.

INSTALL HOOK HOLDER

(a) Set the wire hook in the hook holder and temporarily tighten the wing nut. (b) Wind the chain wire until the hook holder enters the bumper.

NOTE: Due to inertia, the drum will continue to rotate for a short time after the switch it off. To prevent damage to the mechanism, switch off the winch with 300 — 400 mm (11.81 — 15.75 in.) of the chain wire remaining. 4069 (c) Loosen the wing nut and turn the No. 1 support bracket 90°, then tighten wing nut. (d) Disconnect the remote control switch and install the connector cover.

1984 LJ70 RJ70 Repair Manual 38261E: diagram

wion7

Donated by Onur Azeri . cruisercult.com

Parts & tools for this job For Toyota Land Cruiser

As an Amazon Associate we earn from qualifying purchases.