INSTALL CLUTCH SUBASSEMBLY AND BRAKE - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Winch › INSTALL CLUTCH SUBASSEMBLY AND BRAKE - Toyota Land Cruiser J70 Workshop Manual
INSTALL CLUTCH SUBASSEMBLY AND BRAKE

WI-54 WINCH — Electric Winch oe
10.
INSTALL CLUTCH SUBASSEMBLY AND BRAKE
SHAFT (a) Put the clutch subassembly into the gear case cover. (b) Install a new O-ring to the brake shaft. (c) Install the brake shaft into the gear case cover through the clutch subassembly.

NOTE: Align the pin hole of the brake shaft and gear case cover as shown. (d) Using a pin punch and hammer, tap in a new slotted 6897 spring pin. 11,
INSTALL NEW GASKET AND GEAR CASE COVER
(a) Place a new gasket and gear case cover on the gear case, (b) Install the set bolts together with the ground cable as shown. Torque the bolts. Torque: 195 kg-cm (14 ft-lb, 19 N-m)
NOTE: Gradually tighten each bolt in several passes in the sequence shown. wi0098
INSTALL WINCH INPUT SHAFT
12.
(a) Install the spacer to the input shaft with the E-ring. (b) Install the input shaft into the gear case cover.
wi0088
INSTALL NO.2 DRUM SPACER AND DRUM
13.
Install the spacer and drum on the gear case.
14.
INSTALL NO.1 DRUM SPACER AND DRUM
HOUSING Install the spacer and drum housing on the drum,
INSTALL REAR BASE MEMBER
15. Install the rear base member to the winch with two bolts. Torque the bolts. Torque: 380 kg-cm (27 ft-lb, 37 N-m)
wiot00|
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- PARTClutch kitSearch: Toyota Land Cruiser clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Toyota Land Cruiser manual gearbox oil
As an Amazon Associate we earn from qualifying purchases.