INSTALL SNAP RINGS - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Winch › INSTALL SNAP RINGS - Toyota Land Cruiser J70 Workshop Manual
INSTALL SNAP RINGS


WINCH — Mechanical Winch (e) Align the matchmarks on the yoke and shaft. 12-mm Socket Wrench (f) Install new spider bearings in the shaft side using the procedure in steps (c) and (d).
INSTALL SNAP RINGS
(a) Install two snap rings of the same thickness which will allow 0 — 0.15 mm (0 — 0.0059 in.) of axial play.
NOTE: Do not reuse the snap rings.
Snap ring thicknesses Thickness
mm (in.)
[ Color |
1.20 (0.0472) None — or 1,25 (0.0492) Brown — oS | __
1.30 (0.0512) | Blue |
(b) Using a plastic hammer or copper hammer, tap the | yoke until there is no clearance between the bearing outer race and snap ring.
CHECK SPIDER BEARING
(a) Check that the spider bearing moves smoothly.
Check the spider bearing axial play.
(b) Bearing axial play: Less than 0.15 mm (0.0059 in.)
04052
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Land Cruiser
As an Amazon Associate we earn from qualifying purchases.