Workshop Manuals Factory service & repair Vauxhall
Vauxhall Astra J17 · Steering
17 · Steering & suspension

Checking and Adding Power Steering Fluid (Power Steering System)

Make
Vauxhall
Model
Astra J
Section
Power Steering System › Repair Instructions › Checking and Adding Power Steering Fluid
SteeringChecking and Adding Power Steering Fluid

Checking and Adding Power Steering Fluid

Caution: When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks.

1. Clean the area surrounding the reservoir cap.
2. Remove the reservoir cap.
3. Inspect the power steering pump fluid level at regular intervals. Use the appropriate procedure below.
  Add fluid when required. Refer to Fluid and Lubricant Recommendations .

Fluid Is Hot

  3.1 Run the engine until the fluid reaches about 80°C (170°F).
  3.2 Turn the engine OFF.
  3.3 Remove the reservoir cap.
  3.4 Inspect the fluid level on the capstick.
  3.5 Ensure that the fluid level is at the HOT/FULL/MAX mark on the capstick.
4. If the fluid level is low, add power steering fluid to the proper level.
5. Install the reservoir cap.
6. When checking the fluid level after servicing the steering system, bleed the air from the system. Refer to Power Steering System Bleeding .

Parts & tools for this job For Vauxhall Astra

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.