Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)22 · Fault diagnosis
22 · Diagnostics

Alarm not working luggage compartment unlocked

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Alarm › Alarm not working luggage compartment unlocked
Fault diagnosisAlarm not working luggage compartment unlocked

ALARM NOT WORKING LUGGAGE COMPARTMENT UNLOCKED

With the alarm on, the boot lid unlocking command is not enabled by the remote control.

The boot lid locking/unlocking command is controlled by the body computer node, which sends a signal to the electric lock through the door management control unit and receives and memorizes the causes of malfunction.

TEST RESULTS
0PRELIMINARY CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Make sure that the central locking system is working properly. In particular, check that the "independent boot" option is disabled.

Then close the doors using the mechanical key.

Move on to Step 1

1. Central locking not working: the doors and the boot lid are not closed/opened simultaneously.

2. Central locking not working: the doors and the boot lid are not closed/opened simultaneously.

1. Proceed with the diagnosis of the central locking system

See table P010 CENTRAL LOCKING NOT WORKING

2. Move on to Step 3

1CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION
Connect the diagnostic equipment to the body computer node and check that there are no errors.Move on to Step 2Presence of errorsContinue as instructed by the diagnostic equipment.
2CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION
Keeping the Examiner diagnostic equipment connected, check, in the parameters mode, that the boot lid opening/closing command using the remote control is correctly received.Move on to Step 3

1. The boot lid opening/closing command using the remote control is not received.

2. The boot lid opening/closing command using the remote control is received.

1. Move on to Step 3

2. Replace lock

3CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION
In parameters mode, check that the remote control(s) is(are) working properly, in particular that the reception is OK for each individual button.Move on to Step 4The individual remote control commands are not received correctlyReplace the broken remote control(s).
4ELECTRICAL CIRCUIT CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check the continuity/insulation of the electrical connection between the boot lid lock and the door management control unitMove on to Step 5Electrical connection interrupted or not insulated.

Restore the damaged electrical connection

See E7015 ALARM

5CORRECT OPERATION CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check that the fault is no longer presentEnd of diagnosis

1. Replace door management control unit

2. Replace body computer

1. Replace door management control unit

Op. 7005N40 CENTRAL LOCKING ELECTRICAL CONTROL UNIT - R R FOLOWING SYSTEM CHECK

2. Replace the body computer node

Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.