22 · Diagnostics

Tilt sensor alarm not working

Fault diagnosisTilt sensor alarm not working

TILT SENSOR ALARM NOT WORKING

When the alarm is switched on using the remote control, the system is activated correctly but the anti-tilt sensor does not intervene

The sensor is connected to the body computer node through an A-Bus serial line.

1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
		TEST RESULTS
	Connect the Examiner diagnostic equipment to the diagnostic socket and check the following at the body computer node in parameters mode: - the presence of the tilt sensor In errors mode: that there are no problems relating to the anti-tilt sensor	Move on to Step 2	Presence of faults	Proceed as instructed by the diagnostic equipment
2	ULTRASOUND SENSORS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the anti-tilt sensor is correctly connected via the A-Bus serial line to the body computer See E7015 ALARM	Move on to Step 3	Connections not correct	Restore the correct connections.
3	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment to the diagnostic socket and check the following at the body computer node. In active diagnosis: the operation of the volumetric modules	End of diagnosis	1. Anti-tilt sensor defective 2. Body computer defective	1. Replace the anti-tilt and ultrasound sensors module. 2. Replace body computer Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.