22 · Diagnostics

Front door closing defective

Make: Fiat
Model: Bravo Factory Service Manual
Year: 2007–2014
Section: Doors › Front door closing defective

‹ Prev Passenger presence sensor does not work Next › Rear door closing defective

Fault diagnosisFront door closing defective

FRONT DOOR CLOSING DEFECTIVE

When the door lock is operated with the key or remote control or from the interior by means of the safety knob, one of the front doors does not close correctly.

If one door does not close correctly when the door lock is operated, the four doors may close and reopen after a few seconds.

1	CHECK LOCK STRIKER	ALL OK	PROBLEMS ENCOUNTERED	ACTION
		TEST RESULTS
	Check that the striker fastening is correct.	Move on to Step 2	Incorrect striker fastening.	Check that the striker fastening is correct Op. 7005A10 FRONT SIDE DOOR - ADJUST STRIKER AND ADAPT SEAL IF NECESSARY
2	DOOR CONTROLS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the door opens/closes correctly by operating the: - Key - Safety knob - Exterior handle - Interior handle	Move on to Step 3	1. Fault in the key. 2. Fault in the knob. 3. Fault in the exterior handle. 4. Fault in the interior handle.	1. Move on to Step 5. 2. Move on to Step 5. 3. Move on to Step 3. 4. Move on to Step 4.
3	EXTERIOR HANDLE CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the condition of the exterior handle.	Move on to Step 5	Exterior handle defective.	Replace the exterior handle Op. 7005C11 FRONT SIDE DOOR EXTERIOR HANDLE - R.R
4	INTERIOR HANDLE CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the condition of the interior handle.	Move on to Step 5	Interior handle defective.	Replace the interior handle Op. 7005E10 FRONT SIDE DOOR INTERIOR PANEL - R.R.
5	LOCK FASTENING CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the lock is correctly fastened to the door.	Move on to Step 6	Fault in lock fastening.	Restore the correct fastening of the lock Op. 7005M26 ELECTRIC WINDOW MECHANISM FOR ONE FRONT DOOR LH OR RH - R.R
6	RODS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the control and/or safety links are correctly fastened to the lock and handle.	End of diagnosis	1. Control rods attachment not correct. 2. Control rods attachment not correct.	1. Renew the correct fastening of the control links 2. Renew the correct fastening of the safety link

‹ Prev Passenger presence sensor does not work Next › Rear door closing defective

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.