Central locking / not working with remote control
- Make
- Fiat
- Model
- Bravo Factory Service Manual
- Year
- 2007–2014
- Section
- Doors › Central locking / not working with remote control
CENTRAL LOCKING / NOT WORKING WITH REMOTE CONTROL
When the door closing/opening is controlled using the remote control, the central locking does not work.
The Body Computer Node receives the signal from the remote control via the RF aerial. Having received the command, it sends the opening/closing signal to the door management control unit and from there to the door actuators and to the luggage compartment actuator.
| TEST RESULTS | ||||
| 1 | CHECK ON OPERATION OF REMOTE CONTROL | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
|---|---|---|---|---|
Check that the remote control battery is not run down. See Test 5580EA ANTI-THEFT DEVICE REMOTE CONTROL OPERATION CHECK | Move on to Step 1 | 1. Battery run down. 2. Incorrect operation of remote control. | 1. Replace the remote control battery. 2. Replace the remote control and program the new remote control in the Body Computer | |
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
| Connect the Examiner diagnostic equipment to the Body Computer Node and check that there are no errors. | Move on to Step 3 | Error detected: RF receiver broken | Move on to step 4 | |
| 3 | CHECK USING DIAGNOSTIC EQUIPMENT | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
Keeping the diagnostic equipment connected to the Body Computer node, check the following in the parameters mode: - that the remote control is correctly programmed; - the operation of the individual remote control buttons. | Move on to Step 4 | 1. Remote control not properly programmed. 2. Remote control defective | 1. Programme the remote control. 2. Replace the remote control and program the new remote control in the Body Computer | |
| 4 | ELECTRICAL CIRCUIT CHECK | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
| Check that the RF receiver aerial is not interrupted or incorrectly connected to the Body Computer Node. | Move on to step 5 | 1. Aerial lead broken. 2. Aerial lead connector not correctly connected to the Body Computer Node. | 1. Restore the continuity/insulation of the aerial lead 2. Correctly connect the aerial lead connector to the Body Computer. | |
| 5 | CHECK ON CORRECT OPERATION OF BODY COMPUTER | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
| Check that the body computer is working properly | End of diagnosis. | Body Computer not working properly | Replace Body Computer | |
Parts & tools for this job For 2007 Fiat Bravo
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Fiat touch up paint
- PARTPanel clip assortmentSearch: Fiat panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.