Anti-theft device remote control operation check

Make: Fiat
Model: Bravo Factory Service Manual
Year: 2007–2014
Section: Special accessories › Anti-theft device remote control operation check

‹ Prev Cruise control set- control check Next › Siren operation check

Electrical equipmentAnti-theft device remote control operation check

ANTI-THEFT DEVICE REMOTE CONTROL OPERATION CHECK

Check 5580EA

The remote control is supplied by a CR2032 lithium battery (3V, 220 mAh), remote control operation is ensured between 2.6 and 3.6 V with a maximum current of 15 mA.

At least 9000 activations of 1second''s duration and 3000 activations of 5 seconds'' duration are guaranteed over a period of two years.

The battery voltage is monitored to check the charge level: the threshold is set at 2.6 V ±0.06 V. If the receiver detects that the battery is flat, it is still possible to carry out a total of 100 operations.

Operating frequency: 433.92 MHz

STEP	CHECK TO BE PERFORMED	REMEDIAL ACTION IF THE CHECK IS NOT OK
1	Battery voltage check using Examiner Take out the remote control battery and connect an Examiner in Voltmeter mode to the terminals with the correct polarity. Check that the voltage exceeds 2.2 Volts.	Replace the battery
2	Variable code re-synchronisation Note that after replacing the battery, the remote control variable code must be re-synchronised: this operation is carried out by pressing the locking button on the remote control key twice. Note that if the remote control has been activated more than 255 times, variable code synchrony between the sending unit and the receiver will be lost (the receiver will no longer be able to identify a variable code message correctly). Synchrony should therefore be restored by pressing the locking button on the remote control unit key twice.

STEP

CHECK TO BE PERFORMED

REMEDIAL ACTION IF THE CHECK IS NOT OK

Battery voltage check using Examiner

Take out the remote control battery and connect an Examiner in Voltmeter mode to the terminals with the correct polarity.

Check that the voltage exceeds 2.2 Volts.

Replace the battery

Variable code re-synchronisation

Note that after replacing the battery, the remote control variable code must be re-synchronised: this operation is carried out by pressing the locking button on the remote control key twice.

Note that if the remote control has been activated more than 255 times, variable code synchrony between the sending unit and the receiver will be lost (the receiver will no longer be able to identify a variable code message correctly). Synchrony should therefore be restored by pressing the locking button on the remote control unit key twice.

‹ Prev Cruise control set- control check Next › Siren operation check

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.