Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)22 · Fault diagnosis
22 · Diagnostics

Luggage compartment does not open with remote control

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Doors › Luggage compartment does not open with remote control
Fault diagnosisLuggage compartment does not open with remote control

LUGGAGE COMPARTMENT DOES NOT OPEN WITH REMOTE CONTROL

The boot lid does not open when the remote control is operated.

The opening command for the boot lid is received by the body computer node via the internal RF receiver; the body computer node commands the door management control unit which unlocks the boot lid lock and releases it gently, disabling the alarm (if fitted).

TEST RESULTS
0PRELIMINARY CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check the condition of the boot locking/unlocking system protective fuseMove on to Step 1.Fuse burnt out.Replace the fuse (identifying the cause of the problem).
1CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION
Keeping the Examiner diagnostic equipment connected, check that there are no errors in the Body Computer Node and in the door management control unit.Move on to Step 2Presence of errorsContinue as described by the diagnostic equipment
2CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION
Check the opening of the boot lid in active diagnosis.Move on to Step 3The boot lid does not open.Move on to Step 4
3ELECTRICAL CIRCUIT CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Check the electrical connection between the door management control unit and the boot lid lock.

See E3046 BOOT OPENING

Move on to Step 4

1. Connection broken or not insulated.

2. Electric lock defective

1. Restore the continuity/insulation of the electrical connection

See E3046 BOOT OPENING

Op. 7015B10 SINGLE TAILGATE LOCK - R+R OR REPAIR WITH PANEL/PROTECTION REMOVED

4ELECTRICAL SIGNAL CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Disconnect the electrical connector for the boot lid lock and check for the opening control signal.End of diagnosisOpening control signal missingMove on to Step 5
5DOOR CONTROL UNIT OPERATION CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check that the door control unit is working properly.Move on to Step 6Door management control unit defectiveReplace the door management control unit
6CORRECT OPERATION CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check that the fault is no longer present.End of diagnosis.The fault persists.

Replace the Body Computer Node

Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.