Side lights/no. plate lights not working

Fault diagnosisSide lights/no. plate lights not working

SIDE LIGHTS/NO. PLATE LIGHTS NOT WORKING

When the side light switch is operated, the side light/number plate lights do not work;

The activation signal for the side lights and the no. plate lights is supplied directly by the Body Computer Node.

1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the Examiner diagnostic equipment to the diagnostic socket and check that there are no faults	Move on to Step 2	Presence of faults	Continue following the instructions for the diagnostic equipment
2	ELECTRICAL SYSTEM CHECK	All OK	Problems encountered	Operation
	- Check the continuity and the insulation of the wiring between the Body Computer node and the number plate lights See E2010 SIDE LIGHTS / NO. PLATE LIGHTS - Check that the earth connection for the number plate lights is correct	Move on to Step 3	Wiring between stalk and Body Computer interrupted	Restore the correct electrical connection See E2010 SIDE LIGHTS / NO. PLATE LIGHTS
		Move on to Step 3	Earth reference to number plate lights interrupted	Restore the electrical connection See E2010 SIDE LIGHTS / NO. PLATE LIGHTS
3		All OK	Problems encountered	Operation
	Check that the body computer is working properly	End of diagnosis	Body Computer defective	Replace body computer Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.