Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)19 · Wiring diagrams and electrical functions
19 · Electrical

Navigator functional description

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Instrument panel › Navigator functional description
Wiring diagrams and electrical functionsNavigator functional description

NAVIGATOR FUNCTIONAL DESCRIPTION

Blue&Me

FUNCTIONAL DESCRIPTION

The Bluetooth control unit M162 is supplied directly at pin 16 of connector A from the battery via the line for fuse F39 of the junction unit under the dashboard B2.

The Bluetooth control unit M162 receives an ignition-controlled power supply at pin 32 via the line for fuse F51 of the junction unit under the dashboard B2.

Pin 15 of M162 is earthed.

The CAN line that connects the Bluetooth control unit M162 to the radio P20, the Body Computer M1, the instrument panel E50 and the other system nodes reaches pins 14 and 30 of M162.

The Body Computer M1 is connected to the radio controls on the steering wheel via clock spring D47: pin 27 of connector H of M1 receives the signals for the buttons on the right of the steering wheel, whilst pin 15 of connector H of M1 receives the signals from the buttons on the left of the steering wheel.

The Body Computer M1 receives a direct supply from the battery via the line protected by maxifuse B99 at pin 18 of connector F of the interface with the junction unit under the dashboard B2; the ignition-controlled supply (INT) reaches pin 9 of connector F of the interface with the junction unit B2.

The Bluetooth control unit M162 is connected to the radio P20 - connector E - from pins 5, 22 and 21 with the AUX left, AUX right and AUX earth signals.

The USB port P143 is connected to the Bluetooth control unit M162, to pins 3, 4, 19, 20 and 31 respectively, with signals: signal D+, reference earth, signal D-, 5V power supply and shielding.

The handsfree microphone P26 is connected to pins 8 and 24 of M162.

The navigation controls H135, located next to the front courtesy light, receive an ignition-controlled supply at pin 6 via the line for fuse F49 of the junction unit under the dashboard B2; pin 5 is earthed.

The command for the signalling LED reaches pin 4 from control unit M162, the referenc earth reaches pin 2 from pin 11 of M162, whilst the analogue signal for the buttons pressed leaves pin 1 for pin 28 of M162.

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.