Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)19 · Wiring diagrams and electrical functions
19 · Electrical

Navigator description

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Instrument panel › Navigator description
Wiring diagrams and electrical functionsNavigator description

NAVIGATOR DESCRIPTION

Blue&Me

DESCRIPTION

The Blue&Me system, alongside the Bluetooth technology for using a mobile phone in the vehicle, is also available with a navigation system for reaching a destination speedily and safely.

One is guided to the destination by voice messages and instructions on the instrument panel display.

The navigator makes it possible to:

- enter a new destination

- navigate to a point of interest (which can be selected from a list of categories such as, for example, hotels, restaurants, airports, railway stations, etc.)

- acquire journey information (arrival time, distance from the destination, vehicle position)

- recover the last destinations memorized

- set preference for the type of route to be followed such as, for example, motorway, toll roads,

- simulate the ruote to a prearranged destination in advance.

The GPS consists of an aerial that allows the vehicle to be GPS satellite-located: the aerial is connected to a receiver located in the integrated unit by means of a special shielded cable.

The GSM aerial, on the other hand, is connected to the GSM unit inside the control unit, used for connecting the GPRS data for services such as traffic in real time, navigation, etc. The stylus aerial is fitted at the rear of the roof: it performs three functions (radio/GSM/GPS) because it also incorporates the radio aerial.

Vehicle position is identified by analysing GPS data together with speedometer and reverse gear signals received from the vehicle.

The navigation maps are loaded onto the USB device connected to the USB port on the vehicle.

The control unit that manages the entire system is a CAN node via which information is exchanged with the Body Computer, the instrument panel and the other electronic units (e.g. the navigation system downloads information from the odometer, reverse engagement signal etc. ).

The control unit is also connected to radio controls on the steering wheel (two special keys for this function are provided in addition to the radio control keys).

The entire operation of the system is also managed by voice commands, picked up by the microphone near the front courtesy light.

There are three additional control buttons in the trim in front of the centre courtesy light:

- NAV: launch of the Navigation Menu - display of incoming information with navigation activated

- SOS: access to Roadside Assistance Services

- Info: access to infomobility services

For more details on system operation

See descriptions 5580M ON-BOARD NAVIGATOR

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.