Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)01 · 00 Introduction and technical data
01 · General

Fuel system (page 3 of 3)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Engine
00 Introduction and technical dataFuel system · page 3 of 3
Type of check or adjustment Op. No. Adjust. lever position Rotation speed rpm Supply voltage V Advance check mm Transfer pressure bar Av. capacity per cyl. mm³/cycle Max. disc. btwn 4 flow rates mm³/cycle Operations or checks to be carried out
Anti-stall setting 16 Min 400 12 7 ÷ 9 MIN lever in stop position place a 1.2 mm shim between the max lever/stop
Idle setting 17 Min 400 12 8 ÷ 10 ≤3,0 Remove the anti-stop shim (1.2 mm)
Regulator check 18 Max 2250 12 Make a note of the capacity
Reg. start of int. setting 19 Max 2400 12 23,0 ÷ 25,0
Max no load check 20 Max 2800 12 ≤10 No supply above 11 mm³/cycle
Full load advance check 21 Max 2800 12 5,6 ÷ 6,2
Regulator check 22 Max 2250 12 Check that the capacity is ≥ that measured at point 18
Stop the bench for at least 10 secs and until the internal pressure has gone down to 0 bar
Delay during starting check 23 Max 0 12 -1,9 ÷ 2,6
Enrichment capacity 24 Max 100 12 32,0 ÷ 48,0
End of enrichment 25 Max 110 ÷ 270 12 0 ÷ 0,4 Accelerator lever released
Max. capacity check 26 Max 270 12 ≤35,0
Max. capacity check 27 Max 1350 12 31,0 ÷ 35,0
Full load advance check 28 Max 1350 12 0,6 ÷ 1,8
Max. capacity check 29 Max 2200 12 35,5 ÷ 39,5
Check and/or adjust the length of the cold advance control rod at 65 mm and reconnect it to the valve lever
Advance when cold check 30 Min 400 12 1,3 ÷ 1,7 Insert a 4 mm shim between the Min lever and stop
Advance when cold check 31 Min 400 12 0 ÷ 0,1 Insert a 2 mm shim between the Min lever and stop
Determine "V" outlet internal stage 32 Apply a pressure of 80 bar simultaneously to the 4 high pressure outlets and 2 bar (compressed air) to the diesel inlet union. Fit the special instrument and rotate the pump shaft with a torque of 0.16 N/m until a hardening is obtained, then measure the distance on the dial gauge
Determine engine timing 33 Add 4 mm to the figure measured (point 32) and note the resulting value on the introduction adjustment access hole sealing cap. This value should be set for the engine when cylinder no. 1 is at fDC

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.