Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Removing-refitting injection pump

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Fuel system (1910 TD 100) › Removing-refitting injection pump
10 EngineRemoving-refitting injection pump · page 1 of 3
Diagram showing the location of bolts on the right front wheel arch liner
Diagram showing the auxiliary shaft drive pulley and its fixing bolts

REMOVING-REFITTING INJECTION PUMP

Diagram showing the automatic tensioner being actuated to loosen the auxiliary shaft drive belt
Position the vehicle on a lift, disconnect the positive battery terminal, remove the right front wheel and proceed as follows:
  1. Remove the bolts shown and remove the right front wheel arch liner.
  2. Loosen the bolts shown which fix the auxiliary shaft drive pulley.
  3. Act on the automatic tensioner to loosen the tension at the auxiliary shaft drive belt, then remove the belt.
  4. Remove the lower protection for the timing drive belt.
Diagram showing the lower protection for the timing drive belt and its mounting bolts

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.