Injection pump removal

INJECTION PUMP REMOVAL

1. Let the band (1) slide in the direction shown by the arrow, then remove the accelerator cable from the injection pump releasing it from the attachment pin and removing it from the mounting and adjustment bracket (2).
2. Disconnect the electrical connections shown
3. Disconnect the pipe (1) from the oil vapour separator (2). Undo the nuts fixing the separator (2); a third nut (not illustrated) is at the lower side of the separator.
4. Disconnect the pipe (1) which connects the oil vapour separator to the tappet cover and move the actual separator towards the engine compartment rear partition.