Cancelling errors

Cancelling errors

When the frequency counter reaches 0, the fault and the parameters associated with it are cancelled.

The immediate cancelling of the entire errors memory takes place through the "cancel errors memory" command sent by the diagnostic equipment.

Connector with the diagnostic equipment

The diagnostic socket to which the diagnostic equipment (Examiner or SDC station) is connected is located at the front of the engine compartment on the right hand side (see diagram on page 18).

The exchange of data between the control unit and the diagnostic equipment takes place via a two-way serial line (line K) using the standard Bosch communication protocol.

The diagnostic equipment can supply the following information:

• display of the errors;
• display of the engine parameters;
• active diagnosis

List of errors