10 · Body & interior

Replacing rear wing (7090a 54)* (page 3 of 9)

Make: Fiat
Model: Bravo /Brava (182) Factory Service Manual
Year: 1995–2001
Section: Replacing body panels

70 BodyworkReplacing rear wing (7090a 54)* · page 3 of 9

Where it is not possible to use a spot weld remover, use a special cutter and an ordinary drill (it is also possible to use a normal drill modified as shown in the diagram underneath.

A person using a power drill to remove spot welds from the inner frame of a car door area

Technical diagram showing a drill bit with mm 0,4~ dimension removing material between two metal sheets, with arrows indicating direction

Remove the rear wing taking care not to distort the inner frames.

Side view of a car showing the rear wing removed, exposing the inner frame structure and mounting points along the wheel arch and pillar

Rear three-quarter view of a car with the rear wing removed, showing the exposed inner body structure around the wheel arch and C-pillar

If there are difficulties when removing the wing, it is advisable to heat the section of sealant in the area of the wheel arch and the foam in the upper part of the rear pillar using a hot air blower.

‹ Prev Next ›

Parts & tools for this job For 1995 Fiat Bravo

TOOLTrim removal tool kitSearch: trim removal tool kit
PARTTouch-up paintSearch: Fiat touch up paint
PARTPanel clip assortmentSearch: Fiat panel clips assortment

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.