16 · Electrical

Speed signal check

Electrical equipmentSpeed signal check

SPEED SIGNAL CHECK

Check 5540BN

ABS

STEP	CHECK TO BE PERFORMED	RESOLUTION IF THE CHECK IS NOT OK
1	Turn on the diagnostic tester and go to Instruments. While in Voltmeter mode, select a full scale deflection of 20 V and a time base of 2 s. Connect the voltmeter red probe to Pin 10 of the master headlamp 14-way connector See F010 LEFT HEADLAMP and the red probe to earth. Turn one wheel by hand and when the speed is 4-6 km/h press the START button. Check that the signal acquired looks the attached graph without any dips. The test can be considered over	Move on to Step 2

STEP

CHECK TO BE PERFORMED

RESOLUTION IF THE CHECK IS NOT OK

Turn on the diagnostic tester and go to Instruments. While in Voltmeter mode, select a full scale deflection of 20 V and a time base of 2 s.

Connect the voltmeter red probe to Pin 10 of the master headlamp 14-way connector

and the red probe to earth.

Turn one wheel by hand and when the speed is 4-6 km/h press the START button.

Check that the signal acquired looks the attached graph without any dips.

The test can be considered over

Move on to Step 2

STEP	CHECK TO BE PERFORMED	RESOLUTION IF THE CHECK IS NOT OK
2	Check for wiring continuity between Pin 28 of Body Computer connector B See M001 BODY COMPUTER and Pin 10 of the master headlamp 14-way connector. See F010 LEFT HEADLAMP	The test can be considered over
3	Check for wheel speed signal errors in the ABS control unit	Continue as instructed by the diagnostic equipment
4	Check for wiring continuity between the ABS control unit and the Body Computer See E7020 ABS	Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R
5	Check that the fault is no longer present	Replace the Master headlamp Op. 5540B81 LEFT GAS DISCHARGE LIGHT CLUSTER - R.R.

ESP

STEP	CHECK TO BE PERFORMED	RESOLUTION IF THE CHECK IS NOT OK
1	Turn on the diagnostic tester and go to Instruments. In Voltmeter mode, select a full scale deflection value of 20 V and a time base of 2 s. Connect the voltmeter red probe to Pin 10 of the master headlamp 14-way connector See F010 LEFT HEADLAMP and the red probe to earth. Turn one wheel by hand and when the speed is 4-6 km/h press the START button. Check that the signal acquired looks the attached graph without any dips. The test can be considered over	Move on to Step 2