COOLANT TEMPERATURE SENSOR - R + R

Operation 1056B50 · MULTI-POINT INJECTION SYSTEM (MPI)

2.2

Removing

- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

1. Remove the sound insulation cover fastened to the engine by three pins.

1. Disconnect the electrical connection from the engine coolant temperature sensor.

2. Undo the engine coolant temperature sensor and remove it.

Refitting

- Place the engine coolant temperature sensor in its housing and tighten it to the recommended torque.

Replace the seal.

- Connect the electrical connection to the engine coolant temperature sensor.

- Place the sound insulation cover back in its housing and secure it to the engine using the three pins.

- Connect the negative battery terminal.

1.8

Removing

1. Disconnect the electrical connection for the engine coolant temperature sensor.

2. Lift up the retaining clip and remove the engine coolant temperature sensor.

Refitting

- Position the engine coolant temperature sensor in its housing and secure it using the retaining clip.

- Connect the engine coolant temperature sensor electrical connection.