180,000KM SERVICE

Operation 0010M80 · SERVICE COUPONS FROM 100,000 UP TO 190,000KM - EMISSION CONTROL VERSIONS

1.8, 2.2

- Check the tyre tread is not worn.

Some types of tyre are fitted with wear indicators; they should be replaced as soon as these indicators are visible on the tread.

Do not swap tyres across.

- Check the tyre inflation pressure is correct. Also check the spare wheel.

The tyre pressures must be checked when they are cold.

- Check that the lighting system is operating correctly: headlamps, turn signals, hazard lights, luggage compartment light, passenger compartment light, oddment compartment light and instrument panel warning lights.

- Check the windscreen wiper system is operating correctly and adjust the sprays if necessary.

- Check the front and rear wiper blades are correctly positioned and not worn.

- Check condition and wear of front disc brake pads and operation of pad wear indicator

- Check rear disc brake pad condition and wear

- Carry out a visual check of: exterior bodywork, underbody protection, rigid and flexible pipes (exhaust - fuel system - braking system) rubber elements (boots - hoses - bushes - etc.)

- Check cleanliness of locks, bonnet and boot lids, cleanliness and lubrication of linkage

- Check and, if necessary, top up the engine fluid levels: power steering,

Op. 0010T71 POWER STEERING FLUID CHECK LEVEL AND TOP UP IF NECESSARY

windscreen washer, battery, engine cooling, etc.

2.2

- Check the seal of the power steering system by sight.

1.8, 2.2

- Check exhaust emissions

Op. 1080A10 IDLING C.O. LEVEL - CHECK WITH SPECIAL EQUIPMENT

2.2

- Check and, if necessary, top up the automatic transmission fluid level.

Op. 0010T45 AUTOMATIC TRANSMISSION FLUID CHECK LEVEL AND TOP UP IF NECESSARY

1.8, 2.2

- Check the seal of the evaporation control system.

1.8

- Proceed with replacing the spark plugs

Op. 5510D10 SPARK PLUGS - R+R

1.8, 2.2

- Replace the air filter cartridge.

Op. 1048A14 AIR CLEANER FILTER ELEMENT - REPLACE.

- Replace engine oil and filter

Op. 0010T12 ENGINE OIL AND FILTER - REPLACE

- Replace the brake fluid

Op. 0010T62 BRAKE AND/OR CLUTCH FLUID - REPLACE FLUID INCLUDES WASHING PIPES AND BLEEDING AIR

Indipendentemente dalla percorrenza chilometrica deve essere sostituito ogni 24 mesi.

- Replace the pollen filter.

Op. 5010B08 CLIMATE CONTROL OUTSIDE AIR PURIFYING (POLLEN) FILTER - R.R.

Indipendentemente dalla percorrenza chilometrica deve essere sostituito ogni 12 mesi.

- Connect the Examiner diagnostic equipment to the vehicle diagnostic socket and check the engine operation.

At the end of the service, connect the Examiner diagnostic equipment to the on board diagnostic socket to zero the mileage counter for the days to the starting value and write the details of the service that has been carried out (date, service no., total mileage) in the Trip Computer memory which can only be read using the diagnostic equipment.

Check that the figure has been set in the instrument panel in km or miles depending on the unit of measurement in that country.

1.9 JTD 8v, 1.9 JTD 16v, 2.4 JTD 20v

- Check the tyre tread is not worn.

Some types of tyre are fitted with wear indicators; they should be replaced as soon as these indicators are visible on the tread.

Do not swap tyres across.

- Check the tyre inflation pressure is correct. Also check the spare wheel.

The tyre pressures must be checked when they are cold.

- Check that the lighting system is operating correctly: headlamps, turn signals, hazard lights, luggage compartment light, passenger compartment light, oddment compartment light and instrument panel warning lights.

- Check the windscreen wiper system is operating correctly and adjust the sprays if necessary.

- Check the front and rear wiper blades are correctly positioned and not worn.

- Check condition and wear of front disc brake pads and operation of pad wear indicator

- Check rear disc brake pad condition and wear

- Carry out a visual check of: exterior bodywork, underbody protection, rigid and flexible pipes (exhaust - fuel system - braking system) rubber elements (boots - hoses - bushes - etc.)

- Check cleanliness of locks, bonnet and boot lids, cleanliness and lubrication of linkage

- Check and, if necessary, top up the engine fluid levels: power steering,

Op. 0010T71 POWER STEERING FLUID CHECK LEVEL AND TOP UP IF NECESSARY

windscreen washer, battery, engine cooling, etc.

- Visually inspect condition of auxiliary drive belt/s

1.9 JTD 8v

- Check and, if necessary, adjust tappet clearance

Op. 1036H10 VALVE TAPPETS - CHECK AND ADJUST CLEARANCE, IF NECESSARY

1.9 JTD 8v, 1.9 JTD 16v, 2.4 JTD 20v

- Check emissions/fumes

Op. 1080A20 EXHAUST FUMES - CHECK WITH OPACIMETER

1.9 JTD 16v, 2.4 JTD 20v

- Check and, if necessary, top up the automatic transmission fluid level.

Op. 0010T45 AUTOMATIC TRANSMISSION FLUID CHECK LEVEL AND TOP UP IF NECESSARY

1.9 JTD 8v, 1.9 JTD 16v, 2.4 JTD 20v

- Replace the fuel filter.

Op. 1044B10 FUEL FILTER ASSEMBLY - R + R OR REPLACE

- Replace the air filter cartridge.

Op. 1048A14 AIR CLEANER FILTER ELEMENT - REPLACE.

- Replace engine oil and filter

Op. 0010T12 ENGINE OIL AND FILTER - REPLACE

For versions with DPF, the actual interval for changing the oil and replacing the engine oil filter depends on the vehicle usage conditions and is signalled by the warning light or message (if present) in the instrument panel

- Replace the brake fluid

Op. 0010T62 BRAKE AND/OR CLUTCH FLUID - REPLACE FLUID INCLUDES WASHING PIPES AND BLEEDING AIR

Irrespective of the mileage, it should be replaced every 24 months.

- Replace the pollen filter.

Op. 5010B08 CLIMATE CONTROL OUTSIDE AIR PURIFYING (POLLEN) FILTER - R.R.

Irrespective of the mileage, it should be replaced every 12 months.

- Connect the Examiner diagnostic equipment to the vehicle diagnostic socket and check the engine operation.

At the end of the service, connect the Examiner diagnostic equipment to the on board diagnostic socket to zero the mileage counter for the days to the starting value and write the details of the service that has been carried out (date, service no., total mileage) in the Trip Computer memory which can only be read using the diagnostic equipment.

Check that the figure has been set in the instrument panel in km or miles depending on the unit of measurement in that country.