Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Croma Factory Service Manual (2005-2010)19 · Wiring diagrams and electrical functions
19 · Electrical

Instrument panel - operational description

Make
Fiat
Model
Croma Factory Service Manual
Year
2005–2010
Section
Instrument panel › Instrument panel - operational description
Wiring diagrams and electrical functionsInstrument panel - operational description

INSTRUMENT PANEL - OPERATIONAL DESCRIPTION

The ignition-operated power supply (INT) for the instrument panel E050 reaches pin 1 of connector A via the line for fuse F37 of the junction unit under the dashboard B002; the direct power supply reaches pin 2 of connector A via the fuse line F53 of the junction unit under the dashboard B002; pin 7 of connector A is earthed (earth controlled by the Body Computer M001, pin 36 of connector G).

The instrument panel E050 is connected from pins 3 and 4 of connector A with the Body Computer M001 and via the latter to the entire CAN:

The signal for the electronic speedometer (from brake system control unit M051) arrives via the CAN network. The same signal is replicated by pin 16 of M051 at pin 7 of connector A of Body Computer M001.

The electronic rev counter receives the engine rpm signal received from the engine management control unit M010 via the CAN.

The fuel level gauge is controlled by means of signals coming from the level gauge located in the fuel pump assembly N040 - at pins 4 (positive) and 15 (negative) of connector D of the Body Computer M001 and from there via the CAN to the instrument panel E050.

The insufficient brake fluid level/handbrake warning light is lit up by a signal from the handbrake switch I040 that reaches pin 14 of connector D of the Body Computer M001 or from the signal from the brake fluid level sensor K025 that reaches pin 18 of connector A of M001.

All these signals are transferred via the CAN to the instrument panel E050.

Instrument panel E050 also contains electronic modules which control the adjustment of the brightness of the actual panel and the other controls

See E2530 INSTRUMENT LIGHTING

The TRIP function is illustrated in the relevant diagram

See E4080 TRIP COMPUTER

Instrument panel E050 also contains electronic modules that control the headlamp alignment adjustment.

See E3080 HEADLAMP AGLINMENT CORRECTOR

Instrument panel E050 also contains a warning buzzer. One of its functions is to emit parking sensor signals.

See E3090 PARKING SENSOR

Parts & tools for this job For 2005 Fiat Croma

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.