For the 1.9 JTD;

First of all check whether the ABS warning light and the handbrake warning light come on simultaneously during starting and then go out

Proceed as instructed

See table K062 ABS AND HANDBRAKE WARNING LIGHTS BOTH ON

For the 1.9 JTD;

Connect the Examiner diagnostic equipment to the diagnostic socket.

Check that there are no faults in the ABS control unit

1. Error detected in the control unit

2. No communication with the control unit

1. Continue following the instructions for the diagnostic equipment

2. Restore:

- Connection between the ABS control unit and the diagnostic connector;

- ABS control unit supply

See E7020 ABS

For the 1.9 JTD;

Keeping the Examiner diagnostic equipment connected, carry out the active diagnosis of:

- pump motor;

- solenoid valves.

Replace the ABS electronic control unit - electrohydraulic unit

Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R.

For the 1.9 JTD;

Check the condition of the rear brake caliper pistons

Replace the rear brake calipers

Op. 3310B36 REAR BRAKE CALIPER (ONE), LEFT OR RIGHT - R.R

For the 1.9 JTD;

Visually inspect that there are no bends or constrictions in the brake pipes, bleed the system and check that the fluid comes out evenly from the bleed screws.

Replace the section of pipe affected by the problem

Op. 3340B ABS SYSTEM PIPES

For the 1.9 JTD;

Visually inspect that there is no grease, oil or dirt on the front braking surfaces

Clean, check and eliminate the causes of the problem: if necessary, replace the front pads

Op. 3310A60 FRONT BRAKE PADS - REPLACE