Dismantling distributor heater unit

P3M065H02

• withdraw clip (13) retaining sensor (14) from the evaporator surface opposite the surface facing ducts;
• unscrew fitting (15) of equalization pipe (16) of expansion valve (6) from pipe (7) previously connected to evaporator output duct;
• partly release adhesive foam rubber trim (17) from above pipe (7) and remove the two clips (18) that retain sensitive bulb (19) of expansion valve (6) in contact with pipe;
• unscrew fitting (20) of pipe (12) connected to expansion valve.

P3M065H03

DISMANTLING DISTRIBUTOR HEATER UNIT

• unscrew screws (1) that fasten front part of heater radiator (2) to bottom rear surface of distributor heater unit;
• remove radiator (2) from seat on the above unit;

P3M065H04

P3M050H02