1004b - power unit overview (page 4 of 9)

(Cont. Op. 1004B10)

1. Disconnect the accelerator hose from the throttle case.

1. Take out the fuel recycling pipe from the throttle case.
2. Take out the fuel inlet pipe from the throttle case.

Plug the fuel pipes as soon as they have been taken out, to avoid fuel spillage.

1. Take the coolant pipe out from the thermostat.
2. Take out the absolute pressure sensor pipe.
3. Take out the vacuum intake pipe of the fuel vapours on-off solenoid valve.
4. Take out the brake servo vacuum intake pipe .

1. Disconnect the idle regulation actuator electrical connection

2. Electrically disconnect the throttle position sensor

3. Disconnect the intake air temperature sensor electrical connection

4. Disconnect the single injector (SPI) electrical connection

(Cont.)