Workshop Manuals Factory service & repair Fiat
01 00 General information and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 27 Axle06 33 Braking system07 41 Steering08 44 Suspension and wheels09 50 Auxiliary units10 55 Electrical equipment11 70 Bodywork12 Diagnosis13 Tests14 Wiring diagrams
Fiat Seicento Factory Service Manual (1998-2010)02 · 10 Engine
02 · Engine

Refitting

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Fuel tank and pipes (899) › Refitting
10 EngineRefitting

(Op. 1040A30 continued)

  • Disconnect the negative (-) battery terminal.
NameConnector
BatteryA1
  • Suck up the fuel from the tank using a suitable tool.
  • Remove the rear right wheel (see Op. 4450B11 WHEEL (one) rear - R+R).
  • Raise the vehicle.
  • Remove the rear right supplementary wheel housing (see Op. 7055B42 SUPPLEMENTARY WHEEL HOUSING (one) - R+R).
  1. Disconnect the fuel filler pipe from the tank.
Diagram showing the fuel filler pipe connection point near the rear wheel arch, with callout 1 pointing to the pipe end.
  1. Loosen screws (1a) and pull off the rubber parts (1b) inside the seating of the fuel cap flap.
Diagram of the fuel cap flap assembly showing internal components, with callouts 1a and 1b indicating screws and rubber parts.
  • Move the fuel filler pipe and the fuel vapour reservoir.
  1. Disconnect the charcoal filter hoses (1a) and the anti-capsizing valve (1b).
Diagram showing the fuel vapour reservoir and associated hoses, with callouts 1a and 1b pointing to the charcoal filter hoses and anti-capsizing valve respectively.
  1. Disconnect the over-flow pipe from the fuel filter pipe.
Diagram showing the over-flow pipe connection to the fuel filter pipe, with callout 1 pointing to the pipe.
  • Loosen screws securing the fuel vapour reservoir to the fuel filler pipe.
  • Separate the fuel vapour reservoir from the fuel filler pipe.
  • Remove the fuel filler pipe.

Refitting

  • Install the fuel vapour reservoir on the fuel filler pipe and tighten the retaining screws.
  • Connect the over-flow pipe to the fuel filler pipe.
  • Connect the pipes of the active charcoal filter and the anti-capsizing valves.

(Cont..)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.