10 Engine 1056a30 - throttle case cover - replace. · page 1 of 2
(Cont. Op. 1056A14)
Name
Connector
- Idle actuator
N74
Connect the intake air temperature sensor electrical connection
Name
Connector
- Air temperature sensor
K42
Connect the throttle position sensor electrical connection
Name
Connector
- Throttle position sensor
K56
Connect the single injector (SPI) electrical connection
Name
Connector
- Single injector (SPI)
N71
Insert the brake servo vacuum intake pipe.
Insert the vacuum intake pipe of the fuel vapours on-off solenoid valve.
Insert the absolute pressure sensor pipe .
Insert the coolant pipes on the throttle case.
Connect the accelerator control flexible pipe to the throttle case.
Complete with Op. 1068A10 ACCELERATOR PEDAL CONTROL - Check, adjustment if necessary and lubrication.Insert the fuel intake pipe on the throttle case.
Insert the fuel return pipe on the throttle case.
Reposition the air cleaner cover with the pipes and throttle case air conveyor.
Insert the oil vapours recovery pipe onto the throttle case.
Insert the oil vapours recovery pipe onto the tappet cover.
Tighten the throttle case air conveyor screws.
Hook the air cleaner cover clasps.
Fill the engine cooling system with coolant
Type
Component
Name
Qty
-
Coolant ENGINE COOLANT LEVEL CHECK AND TOPPING UP
Parafu11
-
Connect the negative (-) battery terminal
Name
Connector
- Battery
A1
Remove the body protection cover.
Close the engine compartment.
Remove the vehicle from the hoist.
1056A30 - THROTTLE CASE COVER - REPLACE.
Removal
Open the engine compartment.
Assemble the body protection covers.
Disconnect the negative (-) battery terminal.
Name
Connector
- Battery
A1
Release the air cleaner cover clasps.
Loosen the throttle case air conveyor screws.
Take out the oil vapours recovery pipe from the throttle case.
Take out the oil vapours recovery pipe from the throttle case.
(Cont.)
Original page
02 Engine
