Refitting

Refitting

• Assemble the engine temperature sensor and tighten to the correct torque

To avoid damaging the sensor when reassembling:
- make sure that the wrench is perfectly centred on the hexagonal head of the mounting;
- do not exceed the specified torque.

• Connect the electrical connection of the engine temperature sensor

• Refit the air cleaner cover with the pipes and throttle case air conveyor.
• Insert the oil vapours recovery pipe onto the throttle case.
• Insert the oil vapours recovery pipe onto the tappet cover.
• Lock the throttle case air conveyor screws.
• Hook the air cleaner cover clasps.
• Connect the battery negative (-) terminal

• Fill the engine cooling system with coolant

• Remove the body protection cover.
• Close the engine compartment.
• Remove the vehicle from the hoist.

1056A56 - ENGINE IDLE SELF REGULATION MOTOR - R+R

Removal

• Open the engine compartment.
• Assemble the body protection covers.
• Disconnect the negative (-) battery terminal.

1. Release the air cleaner cover clasps.
2. Unscrew the throttle case air conveyor screws.
3. Take out the oil vapours pipe from the tappet cover.
4. Take out the oil vapours recovery pipe from the throttle case.

1. Remove the air cleaner cover with the pipes and throttle case air conveyor.

1. Take out the fuel return pipe from the throttle case.

(Cont.)