Refitting

(Cont. Op. 1056A44)

Refitting

• Connect the absolute pressure sensor electrical connection

• Insert the absolute pressure sensor pipe.

Always check that the absolute pressure sensor is undamaged and fully inserted on both parts.

• Tighten the nuts that fasten the absolute pressure sensor to the support.
• Connect the negative (-) battery terminal

• Remove the body protection cover.
• Close the engine compartment.

1056A46 - INTAKE AIR TEMPERATURE SENSOR - REPLACE.

Removal

• Open the engine compartment.
• Assemble the body protection covers.
• Disconnect the negative (-) battery terminal.

• Follow Op. 1056A30 THROTTLE CASE COVER - REPLACE.

1. Unscrew the screws (1a) that fasten the intake air temperature sensor (1b) to the throttle case cover (1c) and remove.

Refitting

• Assemble the intake air temperature sensor in the throttle case cover.
• Screw the intake air temperature sensor fastening screws.
• Complete with Op. 1056A30 THROTTLE CASE COVER - REPLACE.
• Connect the negative (-) battery terminal

• Remove the body protection cover.
• Close the engine compartment.

1056A50 - ENGINE WATER TEMPERATURE SENSOR - R+R

Removal

• Position the vehicle on a hoist.
• Open the engine compartment.
• Assemble the body protection covers.
• Disconnect the negative (-) battery terminal.

• Raise the vehicle.

1. Unscrew the engine compartment protection screws.

(Cont.)