Reassembly
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Clutch release control › Reassembly
18 ClutchReassembly
(Cont.d Op.1820E62)
- Remove the support with the automatic clutch electronic control unit from the engine compartment.
Reassembly
- Re-position the support with the automatic clutch electronic control unit in the engine compartment.
- Connect the electrical connection of the automatic clutch electronic control unit
| Description | Connector | |
|---|---|---|
| - | Automatic clutch control unit | M85 |
- Tighten the three screws fastening the electronic control unit support.
- Lower the vehicle.
- Connect the battery (-) terminal
| Description | Connector | |
|---|---|---|
| - | Battery | A1 |
- Remove the protective coverings from the car body.
- Close the engine compartment.
- Remove the car from the car lift.
1820E64 - SUPPORT/POTENTIOMETRIC GEAR DETECTION SENSORS - R+R.
Removal
- Set the car on the car lift.
- Open the engine compartment.
- Assemble the car body protection covers.
- Disconnect the battery (-) terminal
| Description | Connector | |
|---|---|---|
| - | Battery | A1 |
- Carry out Op. 4450B10 WHEEL (one) FRONT - R+R.
- Separate the mileage recorder cable on the gearbox side.
- Slacken the screws (1a) of the potentiometric sensor support (1b).
- Disconnect the electrical connection of the gear engagement potentiometric sensor
| Description | Connector | |
|---|---|---|
| 1 | Gearbox position sensor A (automatic clutch) | K92 |
- Disconnect the electrical connection of the potentiometric gear selection sensor
(Cont.d)
Parts & tools for this job For 1998 Fiat Seicento
- PARTClutch kitSearch: Fiat Seicento 1998 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Fiat Seicento manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.