Workshop Manuals Factory service & repair Fiat
01 00 General information and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 27 Axle06 33 Braking system07 41 Steering08 44 Suspension and wheels09 50 Auxiliary units10 55 Electrical equipment11 70 Bodywork12 Diagnosis13 Tests14 Wiring diagrams
Fiat Seicento Factory Service Manual (1998-2010)03 · 18 Clutch
03 · Transmission

Reassembly

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Clutch release control › Reassembly
18 ClutchReassembly · page 1 of 2

(Cont.d Op.1820E64)

DescriptionConnector
2Gearbox position sensor B (automatic clutch)K93
Diagram showing the support with potentiometric sensors and connectors K93 and K92 being removed from the gearbox area.
  1. Remove the support with the potentiometric sensors.
Close-up diagram of the potentiometric sensor support bracket with electrical connectors labeled K93 and K92.

Reassembly

- Re-position the support with the potentiometric sensors.

When positioning the support with the potentiometric sensors take care to centre the forks of the shafts.

- Connect the electrical connection of the potentiometric gear engagement sensor
DescriptionConnector
-Gearbox position sensor (automatic clutch)K92
- Connect the electrical connection of the potentiometric gear selection sensor
DescriptionConnector
-Gearbox position sensor B (automatic clutch)K93
- Tighten the two screws fastening the potentiometric sensor support. - Connect the mileage recorder cable on the gearbox side. - Complete with Op. 4450B10 WHEEL (one) front - R+R. - Connect the battery (-) terminal
DescriptionConnector
-BatteryA1
- Remove the protective coverings from the car body. - Close the engine compartment. - Remove the car from the car lift.

1820E70 - AUTOMATIC CLUTCH DEVICE GEAR MOTOR - R+R.

Removal

- Set the car on the car lift. - Open the engine compartment. - Assemble the car body protection covers. - Disconnect the battery(-) terminal
DescriptionConnector
-BatteryA1
- Follow Op. 1048A10 COMPLETE AIR CLEANER - R+R. 1. Slacken the screws (1a) fastening the air cleaner support (1b) and remove it.
Diagram showing the air cleaner support assembly with screws labeled 1a and 1b.
- Raise the car. 1. Disconnect the electrical connection of the automatic clutch drive

(Cont.d)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.