Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)03 · 18 Clutch
03 · Transmission

Reassembly (page 2 of 2)

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Clutch release control
18 ClutchReassembly · page 2 of 2

(Cont.d Op.1820E70)

DescriptionConnector
1Automatic clutch driveN90
  1. Disconnect the electrical connection of the drive motor power module
DescriptionConnector
2Drive motor power moduleN91
Diagram showing the automatic clutch solenoid valve connector labeled 1 and a warning symbol labeled 2
  1. Disconnect the electrical connection of the automatic clutch solenoid valve
DescriptionConnector
1Automatic clutch solenoid valveL40
Diagram showing the lower screw (1a) and support (1b) of the automatic clutch gear motor
  1. Slacken the lower screw (1a) of the support (1b) of the automatic clutch gear motor.
Diagram showing screws (1a) fastening the gear motor (1b) to the gearbox
  • Lower the vehicle.
  1. Slacken the screws (1a) fastening the gear motor (1b) to the gearbox.
Diagram showing the tachometric sensor (1a) and clutch lever (1b) in the gearbox area
  1. Remove the tachometric sensor from the gearbox.
  2. Disconnect the clutch lever.
Diagram showing components labeled 1 and 2 near the clutch assembly

(Cont.d)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.