Refitting (page 2 of 2)
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Rear suspension
44 Suspension and wheelsRefitting · page 2 of 2
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| - | Union | RIGID PIPE TO REAR CYLINDERS | M10 | 1.1 |
- Assemble the clip on the union between the rigid pipe to the rear cylinder and the intermediate hose.
- Connect the end of the handbrake cable to the rear drum handbrake control.
- Complete with Op. 4450D10 One rear wheel HUB, lh or rh - R+R. with wheel removed.
- Complete with Op. 3320B30 Rear brake DRUM (one) lh or rh - R+R.
- Lower the vehicle.
- Pull the handbrake lever completely.
- Tighten the rear wheel hub nut to the specified torque
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| - | Nut | REAR WHEEL HUB | M20 | 22.5 |
The rear wheel hub nut must be changed at each disassembly.
- Lower the handbrake lever.
- Complete with Op. 3330A10 BRAKE FLUID - Checking level and topping-up (if required).
- Complete with Op. 3330A18 Front or rear HYDRAULIC BRAKE SYSTEM - Bleeding.
- Complete with Op. 4450B11 Rear WHEEL (one) - R.R.
- Connect the negative (-) battery terminal
| Name | Connector | |
|---|---|---|
| - | Battery | A1 |
- Close the engine compartment.
- Remove the vehicle from the hoist.
Parts & tools for this job For 1998 Fiat Seicento
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTRear shock absorbersSearch: Fiat Seicento 1998 rear shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.